July 31st, 2007

Sidemount Hose Routing


One of the most common issues with sidemount is hose management. All of the hoses that are normally routed behind the head with backmount are now in your face and the cylinders are now under your arms. This past weekend I bumped into some former students, and active sidemount divers at Little River in Branford. One student was commenting about the challenge of hose routing off of the left cylinder. I had the same issue, but found a solution with the Right Angle Adapter. This little product that I brought back from Australia is the solution for around-the-neck hose routing applications.

When sidemounting use the Right Angle Adapter on the left bottle and route the hose around the neck with a standard 28-inch regulator hose. We used to go with a longer, custom length hose (either 36-inch or a standard 40-inch low pressure hose), but the hose would often lift over the head during the dive. The Right Angle Adapter allows me to use the shorter, 28-inch regulator hose and eliminates the hose lift from behind the head. I put the regulator with the Right Angle Adapter on a necklace and it stays in place. Use it on the right cylinder as well for good hose management to keep the hose tucked in tight to the body.

I also use the Right Angle Adapter for single tank, ocean diving on a 40-inch primary hose routed under the right arm. This with a Rite Source gives me maximum streamlining for single tank ocean diving. No extra hoses to get in the way when going for the lobster or the king crab that I just went diving in Norway for.

It’s just a small product, but like a lot of things, it can make a big difference to your dive.



One Response to “Sidemount Hose Routing”

  • I use the Right Angle Adapter on my on-board O2ptima CCR bailout regulator. I put the bailout regulator on an 18″ hose on a necklace around my neck. The Right Angle Adapter keeps the reg lying flat so that it doesn’t tug and also keeps it out of the way of the loop.

    It’s genius.


    Kathleen, August 2nd, 2007 at 11:38 am